USER MANUAL
Peplink Balance Series
http://www.peplink.com -123 / 261 - Copyright © 2015 Peplink
able to access only the data protected by that key.
None - Do not request for PFS when initiating connection. However, since there is no
valid reason to refuse PFS, the system will allow the connection to use PFS if requested
by the remote peer. This is the default value.
Group 2: 1024-bit Diffie-Hellman group. The larger the group number, the higher the
security.
Group 5: 1536-bit is the third option.
This setting specifies the lifetime limit of this Phase 2 Security Association. By default, it is
set at 28800 seconds.
This feature enables you to prioritize the WAN connections used by this VPN profile.
14.2 IPsec Status
IPsec Status shows the current connection status of each connection profile and is
displayed at Status>Interfaces>IPsec VPN.
To Next Page
Loading...
