peplink balance 20 - 10 Configuring the Lan Interface(S)

USER MANUAL
Peplink Balance Series
http://www.peplink.com -79 / 261 - Copyright © 2015 Peplink
10 Configuring the LAN Interface(s)
LAN Interface settings are located at Network>Interfaces>LAN. Begin setting up your
physical LAN by entering IP settings (VLAN configuration will be covered following
physical LAN setup).
IP Settings
IP Address &
Subnet Mask
Enter the Peplink Balance’s IP address and subnet mask values to be used on the LAN. To
enable multiple VLANs, press the button on the top right-hand corner
Network Settings
Name
Enter the name of your network here
Inter-VLAN
routing
Click here to enable Inter-VLAN routing on your local area network.
Captive
Portal
Click here to enable Captive Portal on your local area network.
If drop-in mode will be used, you can configure it in the next section.