7
7500 Series Manual
2 Safety
2.1 Introduction
2.1.1 Contents
This document contains information that you need to use your product throughout the applicable stages of
the product life cycle. These can include the following:
Product identification
Delivery, transport, and storage
Mounting and installation
Commissioning and operation
Maintenance and repair
Troubleshooting
Dismounting and disposal
Warning!
Failure to follow these instructions may impair the safety protection and function of the equipment.
Note!
For complete information on the product, refer to the instruction manual and further documentation at
www.pepperl-fuchs.com.
The documentation consists of the following parts:
Present document
Instruction manual
Datasheet
Additionally, the following parts may belong to the documentation, if applicable:
EU declaration of conformity
Certificates
Control drawings
Additional documents
2.1.2 Target Group, Personnel
Responsibility for planning, assembly, commissioning, operation, maintenance, and dismounting lies with
the plant operator. In accordance with but not limited to IEC/EN 60079-14, only appropriately trained and
qualified personnel may carry out mounting, installation, commissioning, operation, maintenance, and
dismounting of the product. National laws and regulations must be observed and take precedence over
any aspects of IEC/EN 60079-14. The personnel must have read and understood the instruction manual
and any further documentation.
To Next Page
Loading...
Need help?
General
