Restore
Configuration to
Factory Settings
The Restore Factory Settings button resets the configuration to factory default
settings. After clicking the button, click the Apply Changes button on the top right
corner to make the settings effective. To save existing network settings when restoring
factory settings, check the Network Settings box before clicking Restore Factory
Settings.
Download Active
Configurations
Click Download to backup the current active settings.
To restore or change settings based on a configuration file, click Choose File to locate
the configuration file on the local computer, and then click Upload. The new settings
can then be applied by clicking the Apply Changes button on the page header, or you
can cancel the procedure by pressing discard on the main page of the web admin
interface.
7.1.8 Reboot
This section provides a reboot button for restarting the system. For maximum reliability,
your access point can equip with two copies of firmware, and each copy can be a
different version. You can select the firmware version you would like to reboot the
device with. The firmware marked with (Running) is the current system boot up
firmware.
Please note that a firmware upgrade will always replace the inactive firmware
To Next Page
Loading...
