PerkinElmer EnVision User Manual

Workstation software installation instructions
98
4. Set up the system
- Set up the computer
- Install the printer according to the instructions accompanying the printer.
- Connect the CAN cable between the PC and the instrument (or to the
dispenser if installed)
Note! Do not connect the cable to the RS232 port of the PC!
- Connect the instrument and computer to the mains
- Switch the computer on and log in to the EnVision user. See
documentation with the computer for User Name and password.
- Start the service program and run the performance test (see the Service
support folder for detailed information).

PerkinElmer EnVision Specifications

General

Light Source	Xenon flash lamp
Software	EnVision Manager
Read Modes	Absorbance, Fluorescence, Luminescence, Time-Resolved Fluorescence, Fluorescence Polarization
Plate Formats	384-well
Detection Technology	PMT
Temperature Control	Ambient to 45°C