PerkinElmer Lambda 465 Installation Instructions

09931238D
9
6. Place the base plate at the bottom of the sample compartment and tighten the bolt with a
wrench. Next fix and tighten the Peltier Control Single Cell with the Phillips round screw.
Figure 11 Placing the plate at the bottom of the sample compartment
7. Connect the accessory interface cable of the Peltier Controller to the interface connector of the
Peltier Control Single Cell.
Figure 12 Connecting the accessory interface cable of the Peltier Controller to the
interface connector

PerkinElmer Lambda 465 Specifications

General

Brand	PerkinElmer
Model	Lambda 465
Category	Measuring Instruments
Language	English