32 SEBU8605-01
Operation Section
Lifting and Storage
i04195469
Product L ifting
(Clean Emissi
on Module)
g02385036
Illustration 32
Ensure that the correct clothing is worn, refer to
this Operation and Maintenance Manual, “General
Hazard Information”.
The weight of the clean emission module (CEM)
when laden is approximately 50 kg (110 lb). Two
suitable double looped slings are required in order to
lift the CEM. Also a suitable hoist will be required in
order to remove and install the assembly.
The slings must be attached to the CEM in the
positions as shown in illustration 32.
Ensure that the slings only contact the body of the
CEM. A test lift may be required in order to achieve
the correct balance of the assembly.
Some applications may require a frame or jig in order
to lift the CEM. A frame or jig must only be connected
to the cradle of the CEM. Refer to the OEM for more
information.
i04084189
Product Storag e
(Engine and Af
tertreatment)
Perkins are not responsible for damage which may
occur when an engine is in storage after a period in
service.
Your Perkins dealer or your Perkins distributor can
assist in pr
eparing the engine for extended storage
periods.
Condition for Storage
The engine
must be stored in a water proof building.
The building must be kept at a constant temperature.
Engines that are filled with Perkins ELC will have
coolant p
rotectiontoanambienttemperatureof
−36° C (−32.8° F). The engine must not be subjected
to extreme variations in temperature and humidity.
Storage Period
An engin
e can be stored for up to 6 months provided
all the recommendation are adhered to.
Storag
e Procedure
Keep a record of the procedure that has been
comple
ted on the engine.
Note: Do not store an engine that has biodiesel in
the fu
el system.
1. Ensure that the engine is clean and dry.
a. If the engine has been operated using biodiesel,
thesystemmustbedrainedandnewfilters
inst
alled. The fuel tank will require flushing.
b. Fill the fuel system with an ultra low sulfur fuel.
For m
ore information on acceptable fuels refer
to this Operation and Maintenance Manual,
“Fluid recommendations”. Operate the engine
for
15 minutes in order to remove all biodiesel
from the system.
2. Dra
in any water from the primary filter water
separator. Ensure that the fuel tank is full.
3. Th
e engine oil will not need to be drained in
order to store the engine. Provided the correct
specification of engine oil is used the engine
ca
n be stored for up to 6 months. For the
correct specification of engine oil refer to this
Operation and Maintenance Manual, “Fluid
r
ecommendations”.
To Next Page
Loading...
