REASSEMBLY
Page: 24
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
Note:
- The circlip gaps (4) must face upwards or
downwards, but under no circumstances to the side
- The circlips must be changed each time they are
removed
To fit the cylinder
- Fit a new bottom gasket (5) without grease or oil to
the casing which has been previously cleaned of all
impurities
- Ensure that the piston ring gaps are opposite the
piston positioning spigots
- Fit the cylinder (6) and lower it while compressing
the rings
- Check that the piston runs freely (2) in the cylinder
To fit the cylinder head
1) Air cooled engine
- Check the condition of the cylinder head mating
surface
- Fit a new cylinder head gasket (7) to the cylinder
(the widest metal ring (A) pointing upwards)
- Fit the cylinder head
- Fit the 4 lockwashers and the 4 nuts
- Tighten the 4 nuts working diagonally, to the
recommended torque
To Next Page
