PEUGEOT MOTOR ENGINE - Disassembly; Fitting the Engine to the Support and Adapter; To Remove the Drive Pulley - Types 1 and 2

DISASSEMBLY
Page: 8
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
DISASSEMBLY
Fitting the engine to the support and adapter
- Fit the engine to adapter P/N 65255 using a nut and
bolt (1) diameter 8 x 110 mm
- Protect both ends of the engine mount with 2
washers (2)
- Fit the engine with its adapter to the stand P/N
64765, with the stand held in a vice
To remove the drive pulley - types 1 and 2
- Lock the clutch drum (1) with the strap 68460
- Remove the nut (2) from the end of the crank
assembly
- Remove the drive pulley not forgetting the washer
(3) under the drum