PEUGEOT MOTOR ENGINE - Changing the Starting Jaws (with and Without Governor) Types 1 and 2; To Assemble the Governor - Type 2

MISCELLANEOUS OPERATIONS
Page: 35
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
Changing the starting jaws (with and without
governor) types 1 and 2
To fit the return springs
- Fit the large loop on the spring inside slot (A) on
the pivot and hook it on the pivot pin (B) (the
spring loop openings should be facing the inside of
the jaw)
- Hook the other end of the spring to the second
peg (C) on the jaw
- Fit the cup (1C)
To assemble the governor - type 2
Governor composition
( main components )
- Bobweight support plate (1D)
- Bobweights (1E)
- Bobweights spindles (1F)
- Governor drive (1H)
- Rotating flange (1G)
- Fixed flange (1A)
- Nylon washers (12 and 13)
Special tooling required
- Governor fitting and removal support P/N 750411