PEUGEOT MOTOR ENGINE - Type 3 - Drive Pulley with Governor, with Kickstart; To Fit the Governor (Type 3)

REASSEMBLY
Page: 30
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
Type 3 - drive pulley with governor, with
kickstart
Drive pulley composition
Fitting method
To fit the governor (type 3)
- Fit in the following order:
- the plain washer (1)
- the fixed flange (2)
- the washer (4), the spacer (5), the rotating flange
(3) and the nylatron washer (6)
- the bobweight support (7)
- the plain washer (8)
- the nut (9)
- Lock the bobweight support with pin wrench P/N
755586
- Tighten to the recommended torque