PEUGEOT MOTOR ENGINE - To Remove the Coil Assembly and the Stator; To Remove the Magneto Flywheel

DISASSEMBLY
Page: 11
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
To remove the magneto flywheel
- Remove the flywheel cover
- Lock the rotor (1) with tool P/N 755586
- Remove the nut (2) from the end of the crank
assembly
- Fit protective tool P/N 68007 to the crank assembly
- Fully tighten the flywheel extractor tool P/N 69254
on the rotor
- Lock the rotor with the adjustable pin wrench
P/N 755586
- Tighten the flywheel extractor thrust bolt until the
rotor is freed
To remove the coil assembly and the stator
Type 1: 6-pole assembly
- Remove the 2 bolts (3) from the coil assembly (5)
and the 2 bolts (4) from the sensor (6)
- Remove the coil assembly