Set-up
33
9.10 Setting the number of remaining stitches for the bobbin thread monitor
There is still an amount of remaining thread on the bobbin when the bobbin thread monitor
signals that the bobbin thread has been used up.
O Switch the machine on.
O Call up "Entry" mode.
O Call up parameter '660'.
O Switch on the bobbin thread monitor (value "1").
Explanation of the values for parameter "660" (bobbin thread monitor)
0 = off
1 = remaining thread counter on
2 = bobbin thread reverse counter on
A 660
1
A 100
100
To Next Page
Loading...
