Input
62
11.05 Error messages and description
Error Description
ERROR: 1 Pedal not at neutral position
ERROR: 3 SM 1 Edge guide (for reference)
ERROR: 4 SM 2 Feed regulator (for reference)
ERROR: 5 Control panel
ERROR: 6 OTE
ERROR: 7 Can node missing (if bobbin changer can node is missing)
ERROR: 8 Zig-zag sensor
ERROR: 9 Starting lock-out at standstill
ERROR: 10 Wrong machine class
ERROR: 20 Incorrect software version on BDF - P1
ERROR: 27 SD card
ERROR: 40 Transmitted light sensors
ERROR: 45 Bobbin thread monitor
ERROR: 46 Bobbin changer if timeout
ERROR: 47 Bobbin changer empty (if magazine is empty)
ERROR: 48 Bobbin changer error with can node suberror
ERROR: 60
Power supply 24 V too low
ERROR: 61 Power supply 24 V too high
ERROR: 62 Short circuit 24 V
ERROR: 63 Overload switch power supply
ERROR: 92 Start inhibitor when motor running
ERROR: 97 SM 1
ERROR: 98 SM 2
ERROR: 100 Non-maskable interrupt
ERROR: 151 System
ERROR: 155 Sewing motor
ERROR: 156 Timeout communication
ERROR: 157 Stepping motor ramps
ERROR: 158 Stepping motor frequency
To Next Page
Loading...
