Pfaff 2481-3/01-980/30 - Entering seam programs

Input
44
11.02 Entering seam programs
Seam programs are created by establishing seam zones which are allocated certain
functions and values. It is possible to store up to 65 seam programs each with 15 seam
zones. The maximum number of seam zones in each seam program and the maximum
number of seam programs can be limited by setting appropriate parameters, see chapter
11.04 Parameter settings.
O Switch the machine on.
O Select the program number, see chapter 9.11 Selecting the seam program.
O Call up seam program input.
Description of the functions
Seam program selection
Opens the menu for entering the seam program number or for selecting the manual sewing
mode, see chapter 9.11 Selecting the seam program.
Edge guide position
Opens the menu for entering the edge guide position, see chapter 9.07 Entering the edge
guide position.
Stitch length
Opens the menu for entering the stitch length, see chapter 9.06 Entering the stitch length.
Selecting the seam type
Shows the current seam program with the corresponding seam zones and opens the menu
for selecting the seam type, see chapter 11.02.01 Selecting the seam types.
Start backtack
Switches the start backtack function on or off.
End backtack
Switches the end backtack function on or off.
3
3