Input
43
11 Input
This chapter describes the input mode functions and how to enter seam programs.
11.01 Input mode
When the machine is in its initial state, it is possible to enter the parameters and the cor-
responding values directly in the control unit. The functions information, adjustment of the
transmitted light sensors and service can be called up.
O Switch the machine on.
O Call up "Entry" mode.
Description of the functions
Sewing mode
Quit the input mode and call up the sewing mode.
Parameter selection
Select the hundred and unit figures of the desired parameters, see chapter11.04.02
Example of a parameter input.
Altering the parameter value
Change the value of the selected parameter, see chapter11.04.02 Example of a parameter
input.
Software information
Calls up information about the current machine software.
Adjusting the transmitted light sensors
Opens the menu for adjusting the transmitted light sensors, see chapter 14.08 Adjusting
the transmitted light sensors in the adjustment manual.
Service
Opens the service menu, see chapter 14.13 Service menu in the adjustment manual.
A 100
100
To Next Page
Loading...
Need help?
General
