2:10
A
B
D
F
C
E
Threading your machine
Turn off the on/off switch
Raise the presser foot. Place the thread on the
spool pin and fit a spool cap, either the same
size or slightly larger than the spool, on top of
the spool.
Using both hands, pull the thread into thread
guide A from the front.
Place the thread from the right underneath the
pre-tension disc B.
Now pass it through the tension disk C in the
left threading slot.
Pull the thread down, around the stop D, into
the right threading slot and up to the take-up
lever E. The thread must be pulled into the take-
up lever from left to right.
Pass the thread down in the right-hand
threading slot.
Pull the thread from the side behind the left
thread guide F.
To Next Page
Loading...
