- Press the TE key (LED on)
- Using the D+ / D- keys set parameter <313> to value 1 (Fig. 8.11)
- Press the paging key until display Fig. 8.2 appears
- Use the A+ / A- keys to set the desired constant programmed speed
- Use the D+ / D- keys to set the desired number of darning cycles
Note:
A setting of "8 darning cycles" executes 8 darning cycles.
A setting of "0 darning cycles" means the function will be executed for as long as
the treadle is pressed!
- Press the TE key (LED off); the darning program is now ready to start.
If required, you can enter thread trimming after completion of the darning cycle
(see Fig. 8.2).
p4xpd-2-en 8.16 08-08-29
Number of darning cyclesDarning program speed
Fig. 8.2
To Next Page
Loading...