p4xpd-2-en 8.3 08-08-29
8.2 Sewing programs
a) Number of sewing programs: 5
b) Seam sections per sewing program: 9
c) Stitch number per seam section: max. 250
d) Assignment of sewing functions to the seam section (see also Chp. 7.7):
- T1 front backtack (on / off)
- T2 end backtack (on / off)
- T3 needle position at sewing stop (up / down)
- T4 thread trimming (on / off)
- T3 presser foot position at sewing stop (up / down)
- T6 presser foot position after end of seam section (up / down)
- T7 sewing with light barrier (on / off)
- T8 function key F1
e) Interrupting the stitch count:
The stitch count in a seam section can be interrupted using treadle position "-2" (fully back). This
status is signalled by an "M" on the display. Sewing can continue without stitch count (manually). By
pressing treadle position "-2" again, the seam section is finished and switched to the next seam
section.
f) Seam section without stitch count:
Seam sections can also be sewn without stitch count (manually). The stitch count is switched off
using key T4.
Manual seam sections are signalled by an "m" on the display.
For a seam section without stitch count, the set stitch number on the display must be ≥1.
Using treadle position "-2", the seam section is finished and switched to the next seam section.
g) Seam section with light barrier control:
The target stitch numbers saved for this seam section are light barrier compensation stitches.
h) Sewing speed:
The sewing speed is separately programmable for each program in the lower line of the display before
start of operation. The maximum programmable sewing speed is limited by parameter <607>
i) Linking sewing programs:
There is the option of having different sewing programs run one after the other.
During programming, the subsequent sewing program is displayed on the lower line by digits 6 and 7
and is set using keys D+ or D−.
01-00 means that only the current program is running; at the end of this sewing program it will
switch back to the start of the same program again.
j) The programs can be used as backtack/darning programs
Change-over is via parameter <313>
To Next Page
Loading...
Need help?
General
