- Press keys A+ / A- and B+ / B- until the desired parameter is displayed.
- Keys D+ or D- are used to enter the desired parameter value.
Switching programming level "b" off
- Press the T/E key, LED off; sewing is possible again.
9.3 Programming level "c" (special level)
Attention!
The control parameters that only have to have their values changed in exceptional cases are
stored at this level. Correcting these parameters may therefore only be carried out by
authorised personnel following consultation with the manufacturer.
Switching programming level "c" on
- Press the T/E key, (LED on).
- Press the paging key until display Fig. 9.4 is displayed; sewing is not possible
- Use keys A+ / A- and B+ / B- to select parameter 798, Fig. 9.4
"a" = programming level, "a", appears on the display, Fig. 9.4
Fig. 9.4
Paging key
PM key, (LED off)
Parameter number
Parameter value "0"
"D" key
TE key, (LED on)
p4xpd-2-en
9.3 08-08-29
To Next Page
Loading...
Need help?
General
