- Use the D+ or D- keys to enter parameter value "11", Fig. 9.5
- "c" = programming level "c" then appears, Fig. 9.5
- Press keys A+ / A- or B+ / B- until the desired parameter is displayed
- Keys D+ or D- are used to enter the desired parameter value.
Note:
At programming level "c", all parameters available in this control unit for all
3 programming levels are displayed!
Switching programming level "c" off
Fig. 9.5
Paging key
PM key, (LED off)
Parameter number
Parameter value "11""D" key
TE key, (LED on)
p4xpd-2-en
9.4 08-08-29
To Next Page
Loading...