Pfaff Powerline 2545 - Thread Catcher Position in Sewing Direction

Adjusting
40
Fig. 1 - 32
1.07.08 Thread catcher postition in sewing direction
Rule
At stitch length setting "0" and the thread catcher 4 in the front turning point position, a
gap of 20 mm should exisit between the thread catcher point and the middle stitch hole.
● Bring the roller lever 1 (screw 2) to the lowest trim curve position 3.
● Turn thread catcher 4 in accordance with the rule
● Make sure that the catcher 5 has no axial player when tighten the screw 2.
2
1
3
4
20 mm
5