Pfisterer MV-CONNEX 3 - Safety; General Safety Precautions

www.psterer.com
7
3 Safety
3.1 Intended use
At the time of its development and manufacture, the product was built ac-
cording to current, accepted rules of engineering and is safe to operate.
However, the product can pose dangers if it is not used by professionally
trained sta, or in an improper or unauthorised manner.
Any use beyond the intended use and / or any other use of the
product is prohibited and is considered not to be as intended.
Any claims against the manufacturer and / or his authorised re-
presentative for damage resulting from improper use of the pro-
duct are excluded. The operator is solely liable for all damages
resulting from improper use.
Operational reliability can only be maintained if the product is used as intended.
It may only be installed when the ambient temperature is within the range
of 0 °C to 45 °C. This refers to the preparation, laying or moving of the cable.
3.2 Changes and modications to the product
To avoid hazards and to ensure optimum performance, no changes nor ex-
tensions or alterations may be made to the product that are not expressly
approved by the manufacturer.
The product may only be operated in a technically awless and operatio-
nally reliable condition. The information given in the installation instruc-
tions must be followed in its entirety!
In addition to the safety precautions and instructions given in this instal-
lation manual applicable to the area of use of the product, local accident
prevention regulations and general safety must be observed and followed
as well as regulations for the protection of the environment.
The operator and personnel authorised by him are responsible for trouble-
free operation of the product and for clear denitions of the responsibili-
ties for installation and repair of the product.
3.3 Responsibility of the operator
Safety
III
Drawings not to scale - for information only Size 3 | 3-S / Standard instructions wire screen / No. 040 371 001 (2014-05-08) i-01