EasyManua.ls Logo

Phcbi MDF-U700VX - TROUBLESHOOTING GUIDE

Phcbi MDF-U700VX
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
TROUBLESHOOTING
If the unit malfunctions, check out the following before calling for service.
<Attention>
If the malfunction is not resolved after checking the following items or if the malfunction is not shown in
the table below, contact our sales representative or agent.
Malfunction Check/Remedy
If nothing operates even
when switched on
The unit is not connected to the power supply.
There is a power failure.
The fuse is blown or the circuit breaker is activated.
An alarm system works
Check the following when a buzzer sounds or when the alarm lamp
lights.
When use starts.
Is the chamber temperature is equal to the set value?
During operation
A little before, has the value of the chamber temperature been
changed significantly?
Had the outer door been left open for a long time?
Did not you put some warm sample into the chamber?
In the above cases, the alarm is canceled with no operation.
“---” flashes in the display
of current value
After turning off (“O”) the battery switch and power switch, turn on (“I”)
power switch, battery switch in this order.
The cooling is poor
The environmental temperature is too high.
The latch of inner door is not closed completely. The outer door
is not closed firmly. (The frost or ice between the cabinet and door
gasket possibly prevents door seal.)
The air intake vent is blocked.
The door is not shut tightly.
The inner lid is not installed correctly.
The set temperature is not set properly.
The grille is blocked out.
The freezer is in the direct sunlight.
There is any heating source near the freezer.
A rubber cap and insulation for the access port are not set
correctly.
You put too many unfrozen articles into the freezer compartment.
The exterior of the unit is
wet with dew.
In case of sultriness or bad location, the exterior of the unit may be
wet with dew. Under a high humidity environment, the cold exterior of
the unit condenses the moisture in the air, so that it is not malfunction.
Wipe the dew with a dry cloth.

Table of Contents

Related product manuals