Mechanical Instructions
EN 17Q528.2E LB 4.
4.3.2 Ambilight
Refer to next figure for details.
1. Unplug the connectors [1].
2. Remove the screws [2].
3. Pull the unit side wards from the back cover.
When defective, replace the whole unit.
Figure 4-17 Ambilight Unit
4.3.3 Woofers
Refer to next figure for details.
1. Remove the screws [1] and lift the whole unit from the back
cover.
Take the speakers out together with their casing. When
defective, replace the whole unit.
Figure 4-18 Woofer
4.3.4 Tweeters
Refer to next figure for details.
Warning: The speakers should never be connected or
disconnected when the set is playing! This can damage the
amplifiers on the SSB.
1. Remove the screws [1] lift the whole unit from the back
cover.
When defective, replace the whole unit.
Figure 4-19 Tweeter
4.3.5 IR & LED Board
Refer to next figure for details.
1. Unplug connectors [1].
2. Use a flat screw driver to release the clip by push in the
indicated direction [2].
3. Lift the board and take it out of the set.
When defective, replace the whole unit.
Figure 4-20 IR & LED Board
H_17650_097.eps
180108
2
1
H_17650_096.eps
180108
1
H_17650_095.eps
180108
2
1
H_17650_098.eps
180108
2
1
To Next Page
Loading...
