Philips 37PFL7603D/10 - Display Supply Panel; Key Board; Small Signal Board (SSB)

Mechanical Instructions
EN 18 Q528.2E LB4.
4.3.6 Key Board
Refer to next figure for details.
1. Unplug the key board connector from the IR & LED board.
2. Remove the screws [1].
3. Lift the unit and take it out of the set.
When defective, replace the whole unit.
Figure 4-21 Key Board
4.3.7 Display Supply Panel
Refer to next figure for details.
1. Unplug connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
Figure 4-22 Display Supply Panel
4.3.8 Small Signal Board (SSB)
Refer to next figure for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
Refer to next figures or details.
1. Unplug the LVDS connector [1].
Caution: be careful, as this is a very fragile connector!
2. Unplug the connectors [2].
3. Remove the screws [3].
4. The SSB can now be taken out of the set, together with the
front shield and the side cover.
5. To remove the shield, remove the screws [4] and lift it of.
6. To remove the side cover remove the screw [5].
7. Release clip [6] and slide the pull the cover side wards from
the SSB.
H_17650_094.eps
180108
1
H_17650_102.eps
180108
1
1
1
2
2
2
2
2
2
2
2
1