Mechanical Instructions
EN 19Q528.2E LB 4.
Figure 4-23 Small Signal Board
4.3.9 LCD Panel / Lightguide
Refer to next figures for details.
1. Unplug the LVDS connector [1].
Caution: be careful, as this is a very fragile connector!
2. Unplug the connectors [2].
3. Remove the fixation screws [3] from rim.
4. Take the rim from the set.
5. Remove the fixation screws [4] and [5].
6. Lift the subframe from the set.
7. The LCD panel can now be lifted from the front cabinet.
When the Lightguide is defective the complete front cabinet
has to be replaced. To do so follow the previous steps to
remove the LCD panel as well as removing the IR LED panel
and Tweeters.
H_17650_103.eps
180108
2
1
3
3
4 4 4
3
3
3
4 4 4
3
5
6
3
3
To Next Page
Loading...
