Philips 37PFL7603D/10 - SSB Replacement Flowchart

Service Modes, Error Codes, and Fault Finding
EN 39Q528.2E LB 5.
5.8.5 SSB Replacement
Follow the instructions in the flowchart in case you have to
exchange the SSB. See figure “SSB replacement flowchart”.
Figure 5-15 SSB replacement flowchart
START
Create “repair” directory on USB stick and
connect USB stick to TV-set
Go to SAM mode and save the TV settings
via “Upload to USB”.
Set is still
operating?
- Replace SSB board by a Service SSB.
- Make the SSB fit mechanically to the set.
Go to SAM mode, and reload settings
via “Download from USB”.
Saved settings
on USB stick?
Program “Display Option” code via 062598
MENU, followed by 3 digits code (this code
can be found on a sticker inside the set).
Check and perform alignments in SAM
according to the Service Manual.
E.g. option codes, colour temperature...
Connect PC via ComPair interface to Service
connector.
END
Yes
After entering “Display Option” code, set is
going to Standby (= validation of code).
Restart the set.
In case of settings reloaded from USB , the set type ,
serial number , Display 12NC, are automatically stored
when entering displ ay options .
No
- Check if correct “ Di spl ay Option” code i s pr ogrammed .
- Veri fy “ Opti on Codes” accor ding sticker inside the set .
- Defaul t settings for White drive ...see Ser vi ce M anual
No
Set is starting up & display is OK .
If not already done;
Check latest software on Service website.
Update Main and Standby software via USB.
Q52xE SSB Board swap – v3
VDS/JA Updated 17-10-2008
Set is starting up but no display .
Final check of all menus in CSM.
Special attention for HDMI Keys.
Program “set type number”, “serial number”,
and “display 12NC”.
Update main software in this step, by using
“autorun.upg” file.
Start TV in Jett mode (DVD i+ (OSD))
Open ComPair browser Q52x.
Noisy picture with bands/lines is visible and the
red LED is continuous “on”
(sometimes also the letter “F” is visible ).
Press 5 s. the “Volume minus” button on the local
cntrl until the red LED switches “off”, and then
press 5 s. the MENU button of the local cntrl.
The picture noise is replaced by blue mute!
Unplug the mainscord to verify the correct
disabling of the factory-mode.
Program “Display Option” code via 062598 MENU,
followed by 3 digits code (this code can be found
on a sticker inside the set ).
After entering “Display Option” code, set is going
to Standby (= validation of code).
Restart the set.
Set is starting up in “Factory” mode .
Start-up set.
Set behaviour?
H_16771_007.eps
171008