P12B
11-10-18 Removed whole taster assem ..all pieces were bent and out of whack..especially taster and mounting plate
Still don’t know particulars of the taster finger at the control disc teeth !!!
A. Place the control disc/ in the home/rest position and the P.U.arm
pressed sideways) on the switch. Unscrew the 2 screws of the leaf (A fig.6). The LARGE FLAT disc
press [62]FIG 8 is located in the rest groove. Take out the center pin/SPINDLE. Now push back? [ the
lifting strip[LONG spring was removed
] (B fig.8) completely and the bracket
(K fig.8) against the roller l (123 fig 9) (in opposite direction ?). The lifting strip must again slide slightly
along with it. A distance of approx. 0.3 mm remains between the rounding of the lifting strip and the
sloping side of the lifting disc (82)FIG 8. The
screws (C fig.8) can now be tightened.[when were the 3 screws C fig 8 loosened?] parts show 3; I see only one
30
To Next Page
Loading...
