Glossary49
AUDIO Jack:jack located on the front of the TViVCR which is
used to record audio from another source.
Automatic Channel Setup: process in which the TV/VCR
scans all available channels and places the ones you receive in its
memory. Then, when you push the CH(annel) _/v buttons, you
only scan through channels you receive.
Bands: settings that allow you to tune channels.
• Antenna - VHF (very high frequency; channels
2-13) and UHF (ultra high frequency; channels
14-69),
• Cable - all standard channels can be received without a Cable
Box,
_htness: adjusting increases or decreases the brightness of
the color on the screen.
Color: adjusting pales or brightens the TViVCR color.
Dubbin_ copying a tape using a VCR.
high quality; a feature in the TViVCR circuitry which pro-
vides enhanced picture detail.
Line_ut: The channel to which you set your TViVCR during
dubbing. The line input channel is always channel 00 (A/V IN).
Mode: a TV/VCR operation.
OTR: One-Touch Recording; a timed recording that starts
immediately and records for 30 minutes to eight hours, whichev-
er you specify.
Picture: adjusting increases or decreases the contrast of the pic-
ture on the screen.
Sharpness: adjusting softens or clarifies the picture on the screen.
T_Zp_eeds: how fast the tape travels during playback or
recording.
• SP (standard play) - fastest tape speed (recording time for a
T120 tape is approximately two hours); best picture quality.
• LP (long play) - average tape speed; playback only.
• SLP (super long play) - slowest tape speed (recording time for
a T120 tape is approximately six hours).
Tint: adjusting changes the tints of the picture on the TViVCR
from purple to green.
VIDEO Jack:jack located on the front of the TViVCR which is
used to record video from another source.
To Next Page
Loading...
