A status display will appear when you press the STATUS/EXIT
button or certain function buttons. The contents of the status
display will vary. To choose the status display mode, follow the
steps below.
If you select STATUS ON, then select COUNTER ONLY
OFF: Channel
_;, Whenever you press the STOP/v button or the PLAY/A but- Time
ton, the status display will appear for five seconds. Portions of
/
tionthestatUsbuttons.displayalso may appear when you press other func- L_2HOIf OAM
If you select STATUS ON, then select COUNTER ONLY
ON:
_;_Whenever you press the PLAY/A button, the status display will
appear for five seconds. After five seconds, only the counter will
remain on the screen. Portions of the status display also may _'_i P
appear when you press other function buttons.
I
If you select STATUS OFF:
_;_The status display will not appear when you press function but- Tape
tons. You must press the STATUS/EXIT button to see the sta- Speed
tus display.
Current
Tape
Function
M 1:23:45 SJO 1
C!unter
and
Counter
Memory
Press the MENU button.
Press the PLAY/A button or the STOP/V button to select
VCR SETUP, then press the F.FWD/I_ button.
Press the PLAY/A button or the STOP/V button to select
ON-SCREEN MODE, then press the F.FWD/I_ button.
Press the PLAY/_ button or the STOP/v button to select
STATUS, then press the F.FWD/I_ button so that ON or
OFF appears beside STATUS.
_> ON-SCREEN MODE NWSTATUS [O
COUNTER ONLY [OFF] j
X '"/
If you set STATUS to OFF, go to step 6. If you set STA-
TUS to ON, press the PLAY/_ button or the STOP/v
button to select COUNTER ONLY, then press the
F.FWD/I_ button so that ON or OFF appears beside it.
Press the STATUS/EXIT button.
To Next Page
Loading...
