Philips D270 - Call Volume and Mute Controls; Handling Multiple Calls

EN 15
Adjust the earpiece or speaker
volume
Press / to adjust the volume during
a call.
The earpiece or speaker volume is
adjusted and the phone is back to the
call screen.
Mute the microphone
1 Press during a call.
The handset displays [SECRECY ON].
The caller or recipient cannot hear
you, but you can still hear his voice.
2 Press again to unmute the
microphone.
The handset displays [LINE IN USE].
You can now communicate with the
caller or recipient.
Turn the speaker on or o
Press to turn the speaker on. The handset
displays [SPEAKER ON] and is displayed
on the screen.
Press again to turn the speaker o. Both
[SPEAKER ON] and disappears from the
screen.
Make a second call
Note
This service is network dependent. Check
with your network provider for operation.
1 Press during a call.
The rst call is put on hold.
2 Dial the second number.
The number displayed on the screen
is dialed out.
Answer a second call
Note
This service is network dependent. Check
with your network provider for operation.
When there is a periodical beep to notify you
of an incoming call when you are on another
call, you can answer the call in these ways:
1 Press and / to answer the
call.
The rst call is put on hold, and you
are now connected to the second
call.
2 Press and to switch back to the
rst call.
If you also subscribe to caller ID service, it will
let you see the name and telephone number
of the caller during call waiting.
It may be necessary to change your
telephone service to use this feature.
Contact your telephone service provider if:
• You have both caller ID and call waiting,
but as separate service (you may need to
combine these service);
• You have only caller ID service, or only
call waiting service; or
• You do not subscribe to caller ID or call
waiting services.
There are fees for caller ID services.
In addition, services may not be available in
all areas.
Switch between two calls
Note
This service is network dependent. Check
with your network provider for operation.
Press and / .
The current call is put on hold, and
you are now connected to the other.