Philips D270 - Message Deletion and Delay Settings; Remote Access and PIN Management

EN 38
Note
You can only delete the read messages. No
deleted messages can be recovered.
Delete all old incoming messages
From the base
Press and hold on the base station in
standby mode.
All old messages are permanently
deleted.
From the handset
1
Press .
2 Select [ANS. MACHINE] > [DELETE ALL
OLD], then press to conrm each
selection.
A conrmation request is displayed
on the handset.
3 Press to conrm or to return to
previous menu option.
All old messages are permanently
deleted if you press to conrm.
Tip
When you access the answering machine
remotely, you are recommended to set
the answer delay to [TIME SAVER] mode.
This is a cost eective way to manage your
messages. When there are new messages,
the answering machine picks up the call
after 2 rings; When there no message, it
picks up the call after 3 rings.
Remote access
You can operate your answering machine
when you are away from home. Simply make
a call to your phone with a touch tone phone
and enter your 4-digit PIN code.
Note
The remote access PIN code is the same as
your system PIN. The preset PIN is 0000.
1 Press .
2 Select [ANS. MACHINE] > [TAM
SETTINGS] > [ANSWER DELAY], then
press to conrm each selection.
3 Select [TIME SAVER], [2 RINGS], [4
RINGS], [6 RINGS] or [8 RINGS], then
press to conrm.
The setting is saved.
Note
Make sure that the answering machine
is switched on before this feature can be
applied.
Set the answer delay
1 Press .
2 Select [ANS. MACHINE] > [TAM
SETTINGS] > [RECORD TIME], then press
to conrm each selection.
3 Select [60 S], [120 S], [180 S] or
[UNLIMITED], then press to conrm.
The setting is saved.
Set the record time