Philips D270 - Getting Started with Your Phone; Connecting the Base Station and Power

EN 8
Caution
Make sure that you have read the safety
instructions in Chapter 1 ‘Important safety
instructions’ before you connect and install
your handset.
Note
• Use only the adapters provided.
• Make sure the electrical outlets are not
controlled by wall switches.
• Connect the power adaptor in a vertical
or oor mount position only. The
adapter’s prong is not designed to hold
the weight of unit, so do not connect it
to any ceiling, under-the-table, or cabinet
outlets. Otherwise, the adaptor may not
properly connect to the mains.
• If you subscribe to the digital subscriber
line (DSL) high speed Internet service
through your telephone line, ensure you
install a DSL lter between the telephone
line cord and the power socket. The lter
prevents noise and caller ID problems
caused by the DSL interference. For more
information on the DSL lters, contact
your DSL service provider.
Warning
• Risk of product damage! Ensure that the
power supply voltage corresponds to
the voltage printed on the back or the
underside of the phone.
• Use only the supplied power adapter to
charge the batteries.
Connect the base station
1
Connect each end of the power
adapter to:
• The DC input jack at the back of the
base station;
• The power socket on the wall.
2 Connect each end of the line cord
to:
• The telephone socket at the back of
the base station;
• The telephone socket on the wall.
3 Connect each end of the power
adapter to (for multi-handset
version only):
• The DC input jack at the bottom of the
extra handset charger.
• The power socket on the wall.
3 Get started