Philips D270 - Page 39

EN 39
Activate or deactivate the remote
access
You can allow or block remote access to the
answering machine.
1 Press .
2 Select [ANS. MACHINE] > [TAM
SETTINGS] > [REMOTE ACC.], then press
to conrm each selection.
3 Select [ON] to activate the remote access
or [OFF] to deactivate the remote access,
then press to conrm.
The setting is saved.
Change the PIN code
1
Press .
2 Select [ANS. MACHINE] > [TAM
SETTINGS] > [CHANGE PIN], then press
to conrm each selection.
3 Enter the old PIN, then press to
conrm.
4 Enter the new PIN code, then press
to conrm.
5 Enter the new PIN code again, then
press
to conrm.
The setting is saved.
4 Press a key to carry out a function. See
the Remote access commands table
below for a list of available functions.
Note
• The * must be entered while the outgoing
message is still playing, and the PIN
should follow without any delays.
• If the PIN is entered incorrectly, you will
hear three error beeps, and you can
try again, but if it happens three times
consecutively, the line will be released
automatically.
Note
When there is no message, the phone
hangs up automatically if no key is pressed
in 8 seconds.
Access the answering machine
remotely
1
Make a call to your home number with a
touch tone phone.
2 Enter * when you hear the outgoing
message.
3 Enter your PIN code.
Default PIN is 0000. You will hear a
single conrmation beep if the PIN is
accepted, and you then need to press
5 to start playing any messages.
Key Function
2 Delete the current message.
4 Press once to repeat the current
message from the beginning.
Press twice to listen to the
previous message.
5 Listen to messages.
6 Listen to the next message.
7 Switch the answering machine
on (not available when you
listen to the messages).
8 Stop the current message.
9 Switch the answering machine
o (not available when you
listen to the messages).
Remote access commands