Philips DTP2340 - Adjust DVD;USB Settings

21
[Factory setting]
Resets the digital receiver to its default factory
settings.
Select [Factory setting] and press OK .
Enter ‘0000’ or the last set password at the
[Enter PIN:] fi eld.
To confi rm, select [OK] and press OK . To
cancel, select [Cancel] and press OK .
Note
If you access • [Factory setting] from DVB-T
radio/Live TV mode, only the settings for
DVB-T radio/Live TV mode are reset. Likewise,
if you access [Factory setting] from DVD/USB
mode, only DVD/USB settings are reset.
[System Info]
View software version.
Adjust DVD/USB settings
To access the menu:
Note
Before you access • [DVD/USB Setting] , switch
to [DVD] mode. Press HOME , select [DVD/
USB Setting] and press OK .
1 Press HOME , select [DVD] or [USB] and
press OK .
2 Press HOME , select [System Setting] and
press OK .
3 Select [DVD/USB Setting] and press OK .
4 Select an option and press .
Press •
BACK to return to the
previous menu.
Press • HOME to exit the menu.
[TV Standard]
If the video does not appear correctly, change
the setting. This setting is to match the most
common setting for TVs in your country.
• [NTSC] : for NTSC-system TV.
• [PAL] : for PAL-system TV.
[Display Type]
Select the screen format according to the way
you want the picture to appear on the TV.
• [4:3 Pan Scan] : for standard TV, a full-
height screen display with the sides
trimmed.
• [4:3 Letter Box] : for standard TV, a
‘wide-screen’ display with black bars on
the top and bottom.
• [16:9 Wide Screen] : for wide-screen TV
(frame ratio 16:9).
Adjust system preferences
1 Press HOME , select [System Setting] and
press OK .
2 Select [General Setting] and press OK .
3 Select [Preference] .
See the explanations of these •
options in the following topics.
4 Select an option and press .
Press •
BACK to return to the
previous menu.
Press • HOME to exit the menu.
Change PIN
Set or change the password for locked
programmes, discs and play of restricted
DVDs.
1 At [Old PIN] , press the Numeric buttons
to enter the last set password or the
default password ‘ 0000 ’.
2 At [New PIN] , enter the new password.
3 At [Confi rm New PIN:] , enter the new
password again.
4 Select [OK] and press OK . To cancel,
select [Cancel] , then press OK .
English
EN