Philips DVDR3460 - Connecting the Video Cable; Component Video (Y Pb Pr) Connection

English
13
AU D IO
OUT
S-V ID E O
IN
VIDEO IN
TV
TIPS: Before making or changing any connections, make sure that all the devices are disconnected
from the power outlet.
Step 1: Basic Recorder Connections (continued)
Connecting the video cable
This connection enables you to view the
disc playback from the recorder. You only
need to choose one of the options below
to make your video connection.
Note: Audio connection is required in
order to hear the sound, see the next
section “Connecting the audio cables”.
Option 1: Using a Composite
video (CVBS) cable

Use a composite video cable (yellow
plug) to connect the CVBS OUT jack
on the recorder to the video input jack
(or labelled as A/V In, Video In,
Composite or Baseband) on the TV.
Option 2: Using an S-Video cable

Use an S-video cable (not supplied) to
connect the S-VIDEO (Y/C) -
OUTPUT jack on the recorder to the
S-Video input jack (or labeled as Y/C or
S-VHS) on the TV.
Option 3: Using a Component
(Y Pb Pr) cable
A
Use the component video cable (red/
blue/green - not supplied) to connect the
Y P
B
P
R
-OUTPUT jacks on the
recorder to the corresponding
component video input jacks (or labeled
as Y Pb/Cb Pr/Cr or YUV) on the TV.
B
If your TV accepts Progressive Scan
signal, see the chapter “System Menu
Options – Video Settings – Progressive
Scan” for detailed Progressive Scan
set-up.
IMPORTANT!
The progressive scan video quality is
only available through a Y P
B
P
R
connection and a progressive TV is
required. It is strongly advised to
complete the recorder installation
 rst, before enabling the progressive
scan feature.
Option 1
Option 2
Option 3
OR
OR
1_dvdr3460-97_um_en_26851a.indd 131_dvdr3460-97_um_en_26851a.indd 13 2007-08-27 1:04:31 PM2007-08-27 1:04:31 PM