English
20
Step 3: Installation and Setup (continued)
B
Press OK on the remote control to
continue.
The auto scan menu appears.
Cancel
Auto scan the channels.
Channels found: 10
Auto Scan
100%
OK
BACK
Next Page Prev Page
Note: Make sure you have successfully
made all the required connections to the
recorder, the TV and Satellite Receiver/
Cable Box (if any) and turned them on.
C
The automatic TV channel search starts.
This process may take several
minutes. Once complete, the program list
menu appears.
Program List
OK
BACK
Next Page Prev Page
1 P01 On C03
2 P02 On C13
3 P03 On S08
Sort and rename the programs.
PR Station NICAM CH
Move Up
Move Down
NICAM
Rename
D
In this menu, you can rearrange the
stored channels sequence, rename it or
set your favourite channels list.
If you do not wish to modify/change the
stored channels, press OK on the
remote control to continue, see step
H
.
E
Highlight the preset channel you want to
change, then press W to move to the
action bar at the left of the menu.
F
Use ST keys to select the required
change action.
Sort channel
Highlight { Move Up } or { Move Down }
in the menu and press OK repeatedly to
shift the selected channel to the desired
preset number.
Set the NICAM mode
Highlight { NICAM } in the menu and
press OK to turn on or off the NICAM
mode.
Note: NICAM is a digital sound
transmission system. It can transmit either
one stereo channel or two separate mono
channels. Selects { On } to improve the
sound transmission or { Off } if the
reception is poor.
Rename channel
Highlight { Rename } in the menu and
press OK to show the keyboard screen.
The maximum input is up to 5 characters.
Note: Use W XST keys to navigate in
the keyboard menu and press OK to
select the character/number/symbol. To
end, move to { Finish } in the menu and
press OK.
TIPS: Press OK to go to the next setup page. Press BACK to return to the previous setup page.
1_dvdr3460-97_um_en_26851a.indd 201_dvdr3460-97_um_en_26851a.indd 20 2007-08-27 1:04:32 PM2007-08-27 1:04:32 PM
To Next Page
Loading...
