1-4-6 E9480FIS
This test measures the average jitter and bler values. A
formatted DVD must be loaded into the engine before
executing this nucleus.
091200 Optimising jitter succeeded.
091201 There was a time-out while communicating.
091202 The Basic Engine returned an unexpected result.
091203 The Basic Engine returned an error code.
091204 No acknowledge received from BE.
091205 Unable to send tray in.
091206 Unable to read the disc.
091207 No disc is loaded.
091208 Unknown disc is loaded.
091209 Unable to enter service mode.
Check whether there is a disc inside the BE.
092100 There was a disc inside the set.
092101 Unable to load the tray.
092102 Error received from BE.
Read the TOC from the disc. This gives a good
indication if the BE works properly.
092400 A disc is loaded, TOC info if echoed.
092401 Unable to load the tray.
092402 The BE has not returned TOC info.
092403 Error received from BE.
Enables Automatic Pattern Verification tool on
DVD+RW disc. Start, stop and type of pattern to be
used can be configured by the user. Return pass/fail
result.
092600 The command executed successfully.
092601 Not enough input parameters.
092602 Invalid start address.
092603 Invalid End address.
092604 Invalid pattern.
092605 Sanyo drive init fails.
092606 Failed to close tray.
092607 Failed to get disc type.
092608 Not DVD+RW disc.
092609 Buffer wait failed.
092610 Write command failed. Sensekey = XX,YY,ZZ.
092611 Failed to synchronize chase. Sensekey = XX,YY,ZZ.
092612 Read command failed. Sensekey = XX,YY,ZZ.
092613 Data read back is different from written data.
Enables Automatic Pattern Verification tool on DVD+R
disc. Start, stop and type of pattern to be used can be
configured by the user. Return pass/fail result. Note
that the nucleus does not check that the write address
is the correct next available address according to the
DVD+R disc. This must be taken care of by the user,
otherwise the write command will fail.
092700 The command executed successfully.
092701 Not enough input parameters.
092702 Invalid start address.
092703 Invalid End address.
092704 Invalid pattern.
092705 Sanyo drive init fails.
092706 Failed to close tray.
092707 Failed to get disc type.
092708 Not DVD+R disc.
092709 Buffer wait failed.
092710 Write command failed. Sensekey = XX,YY,ZZ.
092711 Failed to synchronize chase. Sensekey = XX,YY,ZZ.
092712 Read command failed. Sensekey = XX,YY,ZZ.
092713 Data read back is different from written data.
Set the region code in the AV3.
092800 The command executed successfully.
092801 There was a time-out while communicating.
092802 The Basic Engine returned an unexpected result.
092803 The BE returned an error code.
092804 No acknowledge received from BE.
092805 Communicating with the Basic Engine failed.
092806 The user provided wrong input.
Description Error No. Error Description
To Next Page
Loading...
