1-4-7 E9480FIS
Read the region code from the AV3.
092900 The command executed successfully.
092901 There was a time-out while communicating.
092902 The Basic Engine returned an unexpected result.
092903 The BE returned an error code.
092904 No acknowledge received from BE.
092905 Communicating with the Basic Engine failed.
Reset the region counter in the AV3.
093000 The command executed successfully.
093001 There was a time-out while communicating.
093002 The Basic Engine returned an unexpected result.
093003 The BE returned an error code.
093004 No acknowledge received from BE.
093005 Communicating with the Basic Engine failed.
Adjust the DVD-M (with the OPU) with PCBA. (So
adjusts the two PCBS to each other)
093100 The command executed successfully.
093101 There was a time-out while communicating.
093102 The Basic Engine returned an unexpected result.
093103 The BE returned an error code.
093104 No acknowledge received from BE.
093105 Communicating with the Basic Engine failed.
093106 Unable to enter service mode.
093107 This nucleus is not supported by the engine.
Check the communication between the digital board
and the DCB by issuing an echo command.
100000 Communicating with the DCB succeeded.
100001 DCB could not be accessed by the analogue board.
100002 There was no response from the analogue board.
100003 The error code returned from the analogue board is unknown.
100004 There was no response from the front panel.
Get the version of the DCB
100100 Retrieving the version of the DCB succeeded.
100101 DCB could not be accessed by the analogue board.
100102 There was no response from the analogue board.
100103 The error code returned from the analogue board is unknown.
Light the entire display of the DCB, and clear the
display after confirmation.User confirmation is
necessary.The REC and PLAY keys on the local
keyboard are used for this confirmation.The PLAY key
confirms that the test pattern is OK and the REC key
indicates an error. The STOP key is used to exit this
nucleus at any time. The keyboard can also be used for
the same purpose. The O or o key confirms that the
test pattern is OK and the N or n key indicates the user
wants to go to the next test or that there is an error. The
rest of the keys of the keyboard are used to exit this
nucleus at any time.
100200 Lighting the entire display succeeded.
100201 DCB could not be accessed by the analogue board.
100202 There was no response from the analogue board.
100203 The error code returned from the analogue board is unknown.
100206 The DCB did not light all labels.
100207 The user skipped the rest of the test.
100208 The user returned an unknown confirmation.
Check all keys of the keyboard by confirming the key-
code displayed of each key. The PLAY key is used to
confirm this nucleus. However, this key is also part of
the keyboard test itself. Also the REC and STOP keys
are used to exit the test.With the REC key the user
signals a failure, while the STOP key signals the
abortion of the test by the user. To use one of these
three keys for confirmation,failure or abortion, the user
needs to hold the key pressed down for more than one
second. Pressing the keyboard will also stop the test at
any time.
100400 All the keys on the keyboard have been pressed.
100401 DCB could not be accessed by the analogue board.
100402 There was no response from the analogue board.
100403 The error code returned from the analogue board is unknown.
100404 Not all the keys were pressed.
100405 Invalid key code returned.
100406 DCB Keyboard; test failed.
100407 DCB Keyboard; test aborted.
100408 Failed to clear FP buffer.
100409 Test stopped from service port.
Description Error No. Error Description
To Next Page
Loading...
