1-4-11 E9480FIS
Perform an IIC write action on the digital board.
120900 Writing the data over IIC succeeded.
120901 No input specified.
120902 Invalid Bus ID number.
120903 No IIC address.
120904 Invalid IIC address.
120905 No number of bytes input.
120906 Invalid number of bytes.
120907 No Data.
120908 Number of bytes must be > 0 and < 18.
120909 Invalid Data.
120910 Not enough data bytes.
120911 IIC Write failed.
120912 IIC init failed.
Perform an IIC read action on the digital board.
121000 Reading the data over IIC succeeded.
121001 No input specified.
121002 Invalid Bus ID number.
121003 No IIC address.
121004 Invalid IIC address.
121005 No number of bytes input.
121006 Invalid number of bytes.
121007 Number of bytes must be > 0 and < 101.
121008 IIC Read failed.
121009 IIC init failed.
Perform an UART write action on the digital board on a
specified UART.
121100 Writing the bytes to the UART succeeded.
121101 The user provided wrong input.
121102 Writing to the UART failed.
Perform an UART read action on the digital board on a
specified UART
121200 Reading the data from the UART succeeded.
121201 The user provided wrong input.
121202 Reading the data from the UART failed.
The video signal, which is determined by the user
input, is routed from the input to the output. Input is set
with the routing nucleus 1112. All outputs are enabled.
Audio loopthrough is also enabled by this nucleus.
121300 Video LoopthroughStart succeeded.
121302 Invalid input parameters.
121303 Failed to initialise DENC.
121304 Failed to initialise VIP.
121305 DSW not ready for this setting yet.
Stop routing the audio/video input to all the outputs.. 121400 VideoLoopthroughStop succeeded.
Set the slash version of the system.
121700 Setting the slash version succeeded.
121701 Invalid slash version, default version is set.
121702 Setting the slash version failed.
121703 The user provided wrong input.
121705 No DS errCode known for analogue board error:
121706 There was no response from the analogue board.
Get the slash version of the system.
121800 Getting the slash version succeeded.
121801 Getting the slash version failed.
121802 The IIC write failed.
121803 The IIC read failed.
121804 There was no response from the analogue board.
121805 No DS errCode known for analogue board error:
(Re-) Virginize the recorder. User data in the NVRAM
of the analogue board is cleared.
121900 Virginization succeeded.
121901 Virginization on the Analogue Board failed.
121903 No DS errCode known for analogue board error:
121904 There was no response from the analogue board.
Turn on the virgin mode functionality (e.g. the auto
channel search upon startup).
122000 Turning on the virgin mode succeeded.
122001 urning on VirginMode on the Analogue Board failed.
122003 No DS errCode known for analogue board error:
122004 There was no response from the analogue board.
Description Error No. Error Description
To Next Page
Loading...
