Chapter 7
7-42 V60 Ventilator Service Manual 1049766 Rev A
Component Removal/Installation
7.38 Labels Follow these steps to remove and replace labels (Figure 7-39, Figure 7-40.
Figure 7-41, Figure 7-42):
1. Use isopropyl alcohol to remove any remaining adhesive from the
original part. Ensure that surface is clean and dry.
2. Peel backing from new part and press to adhere.
Figure 7-39: Labels: Front of UI
Figure 7-40: Labels: Back of UI
Logo label
Auto-Trak
option label
Product label
PM label
Electrical
safety label
Option labels
To Next Page
Loading...
