MOLTIO
Table of contents Page
5. Service mode
5.1.1. Test Mode in Moltio One Touch Milk Carafe 1
5.1.2. Test Mode in Moltio Automatic and Classic 7
5.2. Error messages 12
5.3.
Saeco Service Center-Quick Start Guide
12
6. Service and maintenance
6.1. Repair Flow 1
7. Disassembly
7.1. Outer Shell 1
7.2. Coee grinder 2
7.3. Grinder blades 2
7.4. Coee grinder adjustment 3
7.5. Solenoid valve 4
7.6. Pin boiler 4
7.7. Steam pipe 4
7.8. Dispenser 5
7.9 Gear motor 6
7.10. Pump 8
7.11. Flow-meter
8
7.12. Boiler
8
7.13.
Flow selector faucet
9
7.14. CPU board
10
7.15.
Programming access for SSC (Saeco Service Center)
10
7.16. KYB interface and display
10
7.17. Fitting and removing Oetiker clamps
11
8. Notes
9. Water circuit diagram
10 Electrical diagram
Table of contents Page
1. Introduction
1.1. Documentation required 1
1.2. Tools and equipment required 1
1.3. Material 1
1.4. Safety warnings 1
1.5 Service Policy 2
1.6.1. External machine parts 3
1.6.2. Internal machine parts 4
2. Technical specications
2.1. Technical specications 1
2.2.1. Specication for the measurement of the coee products
temperature
2
2.2.2. Specication for the measurement of the Milk products
temperature.
3
2.3. Machine parameters and performance 5
3. Brief instructions
3.1.1. Customer menu in the Moltio One Touch Milk Carafe 1
3.1.2. Customer menu in the Moltio Automatic and Classic 3
3.2 Operation, cleaning and maintenance 5
4. Operating logic
4.1.1. Water circuit Moltio One Touch Milk Carafe 1
4.1.2. Water circuit Moltio Automatic and Classic 2
4.2. Coee cycle 3
4.3. Single microswitch 4
4.4. Temperature sensor 4
4.5. Coee grinder 5
4.6. Low bean level detection, dose quantity adjustment, coee
grinder blocked
5
4.7. Dose self-learning (SAS) 6
4.8. Water level detection (water tank) 7
4.9. Descaling request 7
4.10. Water lter 8
MODIFICATIONS TO SERVICE MANUAL
From Rev. To Re v. Chapter Inserted Modied
REV.03 REV.04
01
Par. 1.3. Material
05
Par. 5.3. Saeco Service Center -
Quick Start Guide
06 Par. 6.1. Repair ow
To Next Page
Loading...
