16 Advanced Scanner Configuration Guide
Revision: 2.0 , technical changes excepted
Decode UPC/EAN Supplementals (continued)
Autodiscriminate UPC/EAN Supplementals
Enable 378/379 Supplemental Mode
Enable 978 Supplemental Mode
Enable Smart Supplemental Mode
Decode UPC/EAN Supplemental
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol
without supplementals will be decoded before transmission. The range is from 2 to 30 times. Five or above is
recommended when decoding a mix of UPC/ EAN symbols with and without supplementals, and the
autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two numeric bar codes beginning on
page 51. Single digit numbers must have a leading zero. To change the selection or cancel an incorrect entry,
scan the Cancel bar code on page 51.
Decode UPC/EAN
Supplemental Redundancy
(Default: 7)
To Next Page
Loading...
