22 Advanced Scanner Configuration Guide
Revision: 2.0 , technical changes excepted
Convert EAN-8 to EAN-13 Type
When EAN Zero Extend is enabled, you can label the extended symbol as either an
EAN-1 3 bar code, or an EAN-8 bar code. This affects Transmit Code ID Character and DECODE_DATA
message.
When EAN Zero Extend is disabled, this parameter has no effect on bar code data.
*Type Is EAN-13
Type Is EAN-8
UPC/EAN Security Level
The SE-955 offers four levels of decode security for UPC/EAN bar codes. Increasing levels of security are provided
for decreasing levels of bar code quality. Select higher levels of security for decreasing levels of bar code quality.
Increasing security decreases the scanner’s aggressiveness; so choose only that level of security necessary for the
application.
UPC/EAN Security Level 0
This default setting allows the scanner to operate in its most aggressive state, while providing sufficient security in
decoding most
“
in-spec
”
UPC/EAN bar codes.
*UPC/EAN Security Level 0
UPC/EAN Security Level 1
As bar code quality levels diminish, certain characters become prone to mis-decodes before others (i.e., 1, 2, 7, 8).
If mis-decodes of poorly printed bar codes occur, and the mis-decodes are limited to these characters, select this
security level.
UPC/EAN Security Level 1
To Next Page
Loading...
