30 Advanced Scanner Configuration Guide
Revision: 2.0 , technical changes excepted
Enable/Disable Code 39 Full ASCI
Code 39 Full ASCII is a variant of Code 39 which pairs characters to encode the full ASCII character set.
To enable or disable Code 39 Full ASCII, scan the appropriate bar code below.
Refer to Table B-3 on page B-5 for the mapping of Code 39 characters to ASCII values.
Enable Code 39 Full ASCII
*Disable Code 39 Full ASCII
Note: Trioptic Code 39 and Code 39 Full ASCII cannot be enabled simultaneously. If you get
an error beep when enabling Code 39 Full ASCII, disable Trioptic Code 39 and try again.
Code 93
Enable/Disable Code 93
To enable or disable Code 93, scan the appropriate bar code below.
Enable Code 93
*Disable Code 93
To Next Page
Loading...
