Advanced Scanner Configuration Guide 9
Revision: 2.0 , technical changes excepted
Beep After Good Decode
Scan this symbol to set the scanner to beep after a good decode.
*Beep After Good Decode
Scan this symbol to set the scanner not to beep after a good decode. The beeper still operates during parameter
menu scanning and indicates error conditions.
Do Not Beep After Good Decode
Transmit “No Read” Message
Enable this option to transmit “NR” if a symbol does not decode during the timeout period or before the trigger is
released. Any enabled prefix or suffixes are appended around this message.
Enable No Read
When disabled, and a symbol cannot be decoded, no message is sent to the host.
*Disable No Read
To Next Page
Loading...
