Philips SpeechMike - Introduction; Operational Parameters; Set Default Parameter; Default Parameters

4 Advanced Scanner Configuration Guide
Revision: 2.0 , technical changes excepted
Introduction
This booklet describes the programmable parameters, and provides bar codes for programming the SpeechMike
Barcode.
Operational Parameters
The SpeechMike Barcode is shipped with the factory default settings shown in Table 1. These factory default
values are stored in non-volatile memory and are preserved even when the scanner is powered down.
To change the parameter values:
Scan the appropriate bar codes included in this chapter. The new values replace the existing memory values. The
factory default values can be recalled by scanning the RESTORE DEFAULTS bar code on page 7.
Table 1 lists the factory defaults for all parameters. To change any option, scan the appropriate bar code(s).
Table 1: Factory Default Table
Parameter Factory Default
Set Factory Default All Defaults
Beeper Volume Medium
Beeper Tone Medium Frequency
Beeper Frequency Adjustment 2500 Hz
Beep After Good Decode Enable
Transmit “No Read” Message Disable
Parameter Scanning Enable
Linear Code Type Security Levels 1
Bi-directional Redundancy Disable
Bi-directional Redundancy Disable
UPC/EAN
UPC-A Enable
UPC-E Enable
UPC-E1 Disable
EAN-8 Enable
EAN-13 Enable
Bookland EAN Disable
Decode UPC/EAN Supplementals Ignore
Decode UPC/EAN Supplemental Redundancy 7