Philips TAB8967 - Firmware Update Procedure

EN 26
andstartrmwareupgrading
process.
Ifthereisnonewrmwarefound
inUSBashdrive,Soundbarwill
prompt end user to accept ToU
(Terms of Use) via local display
“ACCEPT TERMS OF USE IN USER
MANUAL - PRESS PLAY”, if ToU
has not been accepted. If user
do not accept the ToU, software
upgrade over the network will
not take place.
If ToU has been accepted,
Soundbarwillperformrmware
upgradeifanewrmwareis
detected from the server.
Ifthereisnonewrmwarefound,
Soundbar will scroll current
rmwareversiononceand
resume to normal operation.
Duringmanualrmware
upgrading process, there are
downloadingandashing
processes.
Downloading process:
• TAB8967 can operate
normally.
• POWER key to enter semi
standby, downloading will
continue. Display should
keep displaying “UPDATING-
KEEP POWER ON”. During
this stage, all local and RC
keyswillhavenoeect
untilrmwareisupgraded
successfully.
• During semi standby, in case
downloading has failed due
to server or network issues,
TAB8967 should cancel the
downloading process and
stay in standby.
• POWER key to enter ECO
standby will interrupt
downloading progress
and user needs to trigger
rmwareupgrading
manually again.
Flashingrmwareprocess:
• All local and RC keys will
havenoeect.
• All current sources such as
C4A/Aiplay streaming, BT
streaming, HDMI In, Optical,
etc will stop its current
operation. This is to ensure
upgrading process will not
be interrupted.
• Keep displaying
“UPDATING-KEEP POWER
ON”.
» Storetheleinto“/update/
data/”folderoftheUSBash
drive.Thermwarelename
should be “update_TAB8967_
Vxxxxx.zip”. <xxxxx> is the
downloadedrmwareversion.
» TAB8967 is turned on.
» Plug in USB drive with the
downloadedrmware.
» Press SETTINGS on RC, press UP/
DOWN to navigate till “MANUAL
UPGRADE” item.
» Press RIGHT key will trigger
upgrading. Display will show
“UPDATING – KEEP POWER ON”
till upgrading has completed.
AUTO UPGRADE
» Before Auto upgrade is enabled,
end user needs to read and
accept the Terms of Use in
manual.