Phocos Any-Grid Series - Page 25

www.phocos.com 24 | P a g e
Indicate s input voltage,input frequency, PV voltage, charging current,
charging power, battery voltage.
Settings menu and Fault Information
Indicates the setting menus
Indicates warning and fault codes.
Warning: flashing with warning code.
Fault: shown with fault code.
Output Information
Indicate s output voltage, outputfrequency, load in % of nominal power,
load in VA, load in Watt and discharging current.
Battery Information
Indicates battery level in 0 ~ 24%, 25 ~ 49%, 50 ~ 74% and 75 ~ 100%
(left to right) increments.
While the battery is charging, the battery indicator shows thefollowing:
Status Battery voltage (48 V model /
24 V model)
LCD Display
All battery
charging
modes except
Floating phase
< 48 V / < 24V 4 bars flash in turns
48 ~ 50 V / 24 ~ 25 V
Bottom bar constantly on and other three bars flash in
turns
50 ~ 52 V / 25 ~ 26 V
Bottom two bars constantly on and other two bars flash
in turns
> 52 V / > 26V
Bottom three bars constantlyon and top bar flas hes
Floating phase. Batteriesare fully c harged.
4 bars constantly on
While the battery is discharging, the battery indicatorshows the following:
Load Percentage Battery voltage (48 V model / 24 V model) LCD screen
Load > 50%
< 44.4 / < 22.2 V 0 ~ 24%
44.4 ~ 46.4V / 22.2 ~ 23.2V 25 ~ 49%
46.4 ~ 48.4V / 23.2 ~ 24.2V 50 ~ 74%
> 48.4 V / > 24.2V 75 ~ 100%
Load < 50%
< 45.4 / 22.7V 0 ~ 24%
45.4 ~ 47.4V / 22. 7 ~ 23.7V 25 ~ 49%
47.4 ~ 49.4V / 23.7 ~ 24.7V 50 ~ 74%
> 49.4 V / > 24.7V 75 ~ 100%